Cut Control; Spec.funct - DURKOPP ADLER 581 Operating Instructions Manual

Programming
Operating Instructions 581 - 01.0 - 05/2016

5.9.11 Cut control

The subitem Cut control is used to set the cutting monitoring.
Parameters in the Cut control subitem
Icon Entry
Cut control

5.9.12 Spec.funct.

You can set the following special functions:
• Only open clamps in the loading position (1)
• Subsequent sewing pattern (2)
• Extended min or max limits (4)
• Open clamps together (8)
• Extra-long buttonholes (16)
Up to 31 combinations are possible here.
Possible
Meaning
value range
• 0 = Off 0-1
• 1 = On
Preset value
1
91