Buttonhole Cycle - DURKOPP ADLER 581 Operating Instructions Manual

Programming
Operating Instructions 581 - 01.0 - 05/2016
5.7

Buttonhole cycle

On the technician level, you can check the cycle time of a button-
hole or the net sewing time required to finish a buttonhole.
Fig. 46: Buttonhole cycle
To view the buttonhole cycle:
1. Activate the technician level ( p. 69).
 The bottom portion of the screen shows 2 time entries.
• 1: Cycle time (measured from the time sewing starts to
the time the upper material clamps open)
• 2: Sewing time (measured from the time sewing starts
to the time sewing ends)
 Changes to the parameters have an effect on cycle time and
sewing time.
71