Removing And Fitting Clamping Plates - DURKOPP ADLER 581 Operating Instructions Manual

Operation
Operating Instructions 581 - 01.0 - 05/2016

4.10 Removing and fitting clamping plates

WARNING
Risk of injury from sharp parts!
Punctures possible.
Remove and fit the clamping plates when the
machine is switched off or in threading mode.
Removing clamping plates
Fig. 25: Removing clamping plates
①
(1) - Clamping plate, left
To remove the clamping plates:
1. Slightly raise the right clamping plate (2) at the back and pull
it backwards.
2. Remove the clamping plate (2) sideways to the right.
3. Slightly raise the left clamping plate (1) at the back and pull
it backwards.
4. Remove the clamping plate (1) sideways to the left.
(2) - Clamping plate, right
②
37