Assembling The Suction Container - DURKOPP ADLER 581 Operating Instructions Manual

Setup
Operating Instructions 581 - 01.0 - 05/2016

7.12 Assembling the suction container

Fig. 92: Assembling the suction container
①
②
③
(1) - Angle piece
(2) - Hose
(3) - Hose
(4) - Container
The cutting waste that occurs during sewing ends up in the suction
container.
To assemble the suction container:
1. Disassemble components 4, 5, 6 and 7 of the suction container
in accordance with the figure.
2. Insert the blanking plug (8).
3. Screw the suction container into the pre-drilled holes below
the oil pan using the screws (7).
4. Tighten the foam (6) with the spring plate (5) again.
5. Tighten the container (4).
6. Connect the hose (3) to the suction container via the injector.
Cutting waste is extracted via the hose (3) into the container (4).
7. Screw the angle piece (1) onto the injector.
8. Connect the suction container with the pressure supply via
the hose (2).
(5) - Spring plate
(6) - Foam
(7) - Screws
(8) - Blanking plug
⑧
⑦
⑥
⑤
④
145