Table of Contents
Advertisement
USER GUIDE
OPERATING PROCEDURE
Slide Control
The control lever is located to the top right hand side of the fire/fascia.
Push the control lever fully down to the 'P' position and hold there until the pilot
lights. Hold for a further 10 seconds to allow a stable flame.
Release the control lever and it will automatically raise to the 'LO' position. The fire
is now at minimum heat setting.
Lift the control lever up to the 'HI' position. You will feel a positive location check
when the lever reaches this setting. The fire is now at the maximum heat setting.
The lever can be moved between the low and high positions to achieve your
desired heat setting.
Lift the control lever fully up to the 'O' position to extinguish the pilot and main burner. The
appliance is now turned off.
It is recommended that for optimum efficiency the flue is primed for 20 minutes of operation. This
can be achieved by running the appliance in its high (maximum heat) setting.
If, for any reason, the fire extinguishes or is turned off then wait 3 minutes for the fire to cool be-
fore attempting to re ignite.
REPLACING THE BATTERY (SLIDE CONTROL ONLY)
The appliance requires one 9V PPS battery and is located behind the ash pan cover, under the
fuel bed. If the battery needs replacing ensure that the + and - positions are aligned correctly.
CERAMIC FUEL BED
Cleaning of the ceramic coals and fuel bed is not recommended as they are fragile and my
break. Light coatings of soot will be burnt off during normal operation of the fire. Do not expose
any of the ceramic parts to water or cleaning agents. Damaged components must be replaced
and can be ordered directly from the manufacturer. The address can be found on the rear page
of this manual.
If the ceramic components require replacing you should refer to the relevant section in this manual
on pages 8-10.
17
Advertisement
Table of Contents
