Table of Contents
Advertisement
APPLIANCE INSTALLATION
Take the remaining two small coals and position them towards the edges as shown in Fig. 11
below.
Fig. 11
Only use the coals that are supplied with this appliance. If replacement coals are required, use
only a full genuine replacement set.
If the appliance uses a slider control then reconnect the slider arm to the gas control pivot.
FASCIA
This appliance can be used with several different Vision Fires fireframes or frets. For full
instructions on how to fit them please refer to the guide that is supplied with them.
If the appliance uses a slide control then it is important that the adhesive control sticker (supplied
with this fire) is fitted to the fascia as per instruction in the fascia fitting guide.
10
Advertisement
Table of Contents
