Fuel Bed Assembly - Vision V1/200/A Installation & User's Instructions

APPLIANCE INSTALLATION
Do not over tighten the cables. Check that there are no gaps
around the foam strips.
Using the sealing tape supplied, create a seal between the
bottom face of the firebox and the fireplace floor.
Reposition the burner and secure with the two screws
previously removed. Connect the supply line to the
appliance. Turn on the gas supply and pressure test the
pipework installation for soundness according to current
standards.
Fig. 5

FUEL BED ASSEMBLY

Carefully unpack all of the ceramic components and position them onto the burner in the
following sequence.
Take the one-piece ceramic coal front and gently place it in front of the ceramic burner (factory-
clamped to the burner tray). Then take the ceramic coal matrix and place it on top of the ceramic
burner. Ensure that the matrix is touching the rear of the one-piece ceramic coal front.
Fig. 6
Fig. 6
8