Work Environment; Items To Prepare; Setting The Hr98X Caxx$Te - Mitsubishi Electric MELDAS 600 Series Instruction Manual

2. Work Environment
Connect the VDS to serial port 1
on the CNC
side of the actual device. If using a notebook personal
computer with a Windows 95 (Windows 98) system as the VDS, the standard "HyperTerminal" program
can be used. Refer to the Appendix for details on how to start "HyperTerminal".
Serial
cable
2.1 Items to prepare
l
M6 Maintenance Tool (HR98x cassette).
*
l
VDS or notebook personal computer that can be used as a VDS.
l
DSUB 25pin serial cable (CNC side connector). Note that because the operation board differs
according to the model, the correct cable must be confirmed.
l
Accuracy driver (required for changing the rotary switch).
2.2 Setting the HR98x castiette
The M6 Maintenance Tool is provided as an HR98x cassette. Set the HR98x as follows.
HR98x card
,Expa"s'l C-BUS
Mount on
C-BUS #2 of the HR113 card
Setting pin : Leave open (no setting pin).
Rotary switch 1 : Use for automatic servo download. Normally set to 0.
Rotary switch 2 : Not used. Set to 0.
-3-