Emr Messages - Mitsubishi Electric MELDAS 600 Series Instruction Manual

'.
4.4 Error messages
Error message
Details
Unrecognized command
The input command is not correct.
Missing parameter
A parameter has not been designated.
Invalid parameter
The parameter is not correct.
C-Bux#2 Card ID Error
The C-BUS#2 card ID cannot be read.
Warning: memory size OxXXXX --> OxXXXX
The memory size for the copy or compare operation
will change
Can't Create Info Area on Q&xx Card
An information area cannot be created when using a
QX card in the backup cassette.
Select Memory Card ID Error
No Info Area
81 k#O is Information Area. Set Bl k#
The card ID of the selected memory cannot be
identified.
There is no information area.
Block #0 is being used as the information area.
Designate a block No.
Can't use 81 k#. OnBoard SRAM Only
The block No. designation cannot be carried out. Use
this block No. designation only when the on-board
SRAM is selected.
Can't use 81 k# on 'QXxxx' Card
Bl k# Over
The block No. designation cannot be carried out
when a QX card is used in the backup cassette.
The designated range of the block No. has been
exceeded. The block No. designation range varies
according to the size of the backup cassette.
ERROR Compare
A comparison error occurred when the Compare
command was executed.
ERROR Erase block
A FROM erasure error occurred.
ERROR compare address OxXXXX = ****
A comparison error occurred when the FROM was
erased.
ERROR Write address OxXXXX
A FROM writing error occurred.
ERROR verify address 0xXxXx
A comparison error occurred when the FROM was
written.
-15-