Mitsubishi Electric MELDAS 600 Series Instruction Manual page 14

2)
Read
This command is used to restore the data written to the backup CEtSSette in the Sekcted memory. lf
the selected
memory
and
backup cassette sizes differ, the
restoration range is as
follows.
-
.
Sel e ded memcfy < Badup cassette
The data before c$yh
% (Note) The data i n
remeins i n this region.
t It is region is cleared br QX Series cassettes.
+ Restoration by block designation
Desianate the block No. when designating a block with a Write command and restoring the backup
data:Refer to the Write command explanation for details on block Nos.
The following shows an execution example.
>2 2 rEnterI
Warning: memory size
Ox4OOOOO --> 0x80000
C-BusR HR437B From --> OnBoard HR113B Sram size=Ox80000
Read 7 fYES:Y(y) / NO:N(n)] --> y lEnter1
SRam Write
OK
Compare
OK
>
. . . r)
*** 9)
a) The data on the backup cassette is restored in the on-board SFIAM.
b) A warning appears when the selected memory is smaller than the backup cassette memory.
c) The selected memory and backup cassette card name, memory type, and copy size is
displayed.
d) This is for confirming the execution. Reading begins if Y is selected.
e) The backup data is restored in the SM.
f) The written data is compared with the original data.
g) "OK" is displayed if the writing finishes correctly.
-ll-