Command Line Mode; Outline; Memory Map - Mitsubishi Electric MELDAS 600 Series Instruction Manual

. . .
7. Command Line Mode
7.1 Outline
This command is used to designate a command and address in a command line, and back it up in the
Ti!i%rnand differs from the method for menu commands 1) to 4) in that the commands are M500
offline monitor-type interactive format commands.
7.2 Memory map
The following shows the memory map.
(Caution) This memory map has the following conditions.
l
The CPU rotarv switch is set between 8 and F.
l
An HR98x card is mounted.
l
The HR98x card setting pin is left open (no setting pin).
l
Non-cache address
1
U
Main CPU (HR113kiRlll) card
$Pooooooo Owboard HR111:4MB
R
DRAM HRl13SMB .
q-1
8MB
~Depmcfng on the
cassette size
Wlepencing on the
[C%UtiOIl]
.
When a QX Series cassette is mounted on the expansion C-BUS of the HR98x, the FROM head
address becomes OxAA800000.
. A CPU exception
interruption will occur and the system will crash if an illegal address is
designated, so be careful when designating the address.
. "'
-27-