Starting Your System - Aquathin PEARL 30 Getting Started

The purified water exits the main assembly from the "TO
TANK" outlet and passes through the tank and the
CARB 6 GAC post-filter before reaching the faucet.
Congratulations! You have completed the installation of
your Aquathin PEARL water purification system. You
are now ready to begin making pure, Aquathin quality
drinking water.

STARTING YOUR SYSTEM

1. Open the chrome faucet on the sink top.
2. Verify the Tank Ball Valve is closed.
3. Slowly open your cold water supply valve. You will
also begin to hear water flowing into the drain.
4. Check the pressure gauge on optional PBA-G.
Record your initial pressure in Appendix B.
5. In approximately 20 minutes you will begin to see
water drip from the faucet.
6. Close the faucet on the sink top, and then quickly
open the Tank Ball Valve to allow the storage tank to
fill. Actual production rate will vary slightly
depending on pressure, but your system will normally
produce up to 45 gallons of water per day, depending
on model. The first tank of water may take longer.
7. DISCARD THE FIRST FULL TANK OF
WATER. Open the faucet and let the water flow
until only a trickle remains. Close the faucet and
allow the tank to fill a second time. You are now
ready to enjoy the great taste of 100% pure, Aquathin
drinking water. (The RO Module contains a
preservative solution that will be flushed after the
first tank of water is produced.)
20 © 2009-2016 Aquathin Corporation. All rights reserved.