Table of Contents
Advertisement
2.
Connect
the
Pump Inlet to the
Feed Assembly
The Platinum Booster
A s s e m b l y
( P B A )
includes both a pump
and a pressure gauge.
Remove the blue plugs
on
the
pump
by
depressing the collets
(figure
D2).
Measure
and
cut
length of the
yellow
yellow
tubing to connect the
pump
to
the
feed
assembly. Insert one end
of the
yellow
tubing to
yellow
the feed assembly outlet
as shown in
Figure D3
(where the sediment pre
-filter was previously
connected).
Insert the "T" connector
of the pressure gauge in
the pump inlet (Note the
arrows indicating the
flow). Refer to
figure
D4.
Insert the
yellow
tubing
yellow
into the
other end
of the
"T" connector.
(Figure
D5)
54
© 2009-2016 Aquathin Corporation. All rights reserved.
Fig. D2: Remove the plugs
a
Fig. D3: Connect yellow
tubing to the feed assembly
Fig. D4: Connect pressure
gauge to pump
Fig. D5: Insert yellow tubing
from the feed assembly to
pressure gauge
Advertisement
Table of Contents
