Aquathin Deionization Module - Aquathin PEARL 30 Getting Started

biological contaminates, including disease causing water-
borne microorganisms. EPA EST. NO. 52531-FL-01
The Aquathin Reverse Osmosis Module used in this
system can tolerate significantly higher concentrations of
oxidizing contaminants like iron and manganese than RO
modules found in other systems, as well as a much higher
degree of hardness. However, there are limitations—the
operating parameters for this module are found in the
Specifications section of this manual.

Aquathin Deionization Module

This stage contains a unique blend of proprietary
deionization resins carefully matched to our Reverse
Osmosis Module and provides superior rejection of
monovalent ions, fluoride, and nitrates; contaminants
only partially removed by reverse osmosis. Including
deionization after reverse osmosis sets Aquathin systems
apart from other ordinary RO systems.
Following the DI resins, there is even more granular
activated carbon to polish the product water for a clean,
fresh taste. The flow rate at this stage provides
tremendous contact time to assure complete removal of
any remaining organic contaminates.
The final stages of our proprietary DI module are
included to prevent the reverse migration of contaminates
into the system. These stages further separate Aquathin
systems from other brands. After carefully combining the
previous components it is essential to integrate these
stages to ensure 99.999% removal of bacteria, cyst, and
virus (EPA EST. No. 52531-FL-01). These stages also
prevent any contaminants from entering the system via
the faucet.
26 © 2009-2016 Aquathin Corporation. All rights reserved.