Table of Contents
Advertisement
function needed to keep your system operating at peak
efficiency and it extends the service life of the reverse
osmosis module. This simple operation has been
automated in the Aquathin PEARL.
If your unit has not been used for more than one week
(e.g. while you are on vacation), drain the storage tank
(use the water for watering plants, etc.) then flush the
module as described above.
3. Filter Replacement
After 12 months of use, it is time to replace the Aquathin
sediment pre-filter, the Aquathin twin carbon filters and
the 4-stage Aquathin Deionization (DI) Module to insure
your
system
is
producing
parameters. After 2-3 years (depending on the level of
contaminants in water), the Reverse Osmosis (RO)
Module should be replaced, along with the post filter
(CARB 6). Replacement modules can be ordered directly
from your local Authorized Aquathin Dealer.
1.
Remove the contents from beneath the kitchen sink
where the Aquathin filter assembly is located.
2.
Turn off the cold water supply line and unplug the
transformer.
3.
Drain ALL the water from the storage tank by
opening the sink mounted faucet.
4.
Place a soft clean towel on the working surface – it
will absorb the small amount of water that will spill
from the modules as they are changed out, and it will
protect the surface of both the table and your
Aquathin cabinet.
5.
Close the faucet and the ball valve on the top of the
storage tank
32
© 2009-2016 Aquathin Corporation. All rights reserved.
water
within
RO/DI
Advertisement
Table of Contents
