Indicators Of System Activity - Aquathin PEARL 30 Getting Started

IMPORTANT: Monitor your system and check for leaks
frequently over the first week.
Most leaks are attributed to tubing not fully seated inside
the Speedfit® fittings. Remove the red lock clip,
compress the collet, and remove the tubing. Re-insert the
tubing until you feel it bottom out on the tubing end-stop.
Replace the red lock clip. This process solves 99% of
leaking connections. If the leak persists, trim ¼" – ½" off
the end of the tubing and try again.

INDICATORS OF SYSTEM ACTIVITY

The main system has five light indicators on the frame.
These are important indicators of the system activity.
The first green light (from left) indicates that the power
is turned on. This light appears when the system is
running, filling, or flushing. It remains lit even when the
tank is full and when the pressure is low.
The second green light (from left) turns on only when
the tank is full. Therefore, when the tank is full, both the
green lights will be lit.
The first amber light (from left) is lit when the system is
active, i.e. when water is either filling or when the system
is flushing. Therefore, if the tank is full and the system is
idle this light will not be lit.
The second amber light (from the left) is lit only when
the system is flushing; flushing is an automated function
in the Aquathin PEARL.
The red light indicates that the water pressure is low. If
this light is turned on, you may need to use the optional
pump system.
21 © 2009-2016 Aquathin Corporation. All rights reserved.