Table of Contents
Advertisement
STARTING YOUR SYSTEM
1. Plugging the unit into an electrical outlet
Once the installations are completed and you have veri-
fied the tubing and connections, you may plug the system
into an approved power source.
2. Setting the clock on the unit
To program your Aquathin system, first you must set the
time on the unit.
To set the time on the unit, refer to
following steps:
First push in the
red "time set
button"
Then rotate the
24-Hour Gear so
that the "time of
day" indicator
shows the current
local time (i.e. if
it is 2 pm your
time, the "time of
day" indicator
should point to
"2p")
When you release the gear, check for firm engage-
ment of the setting (indicated by a clicking sound).
3. Setting the water usage program
Next, the water backwashing program must be set. By
setting the Day Wheel on the MEGACHAR System, the
backwash and rinse cycles can be programmed to occur
17
© 2007-2009 Aquathin Corporation. All rights reserved. Rev 20091029
figure 15
b. Rotate gear
a. Push button
Fig. 15. (a) push the red button,
(b) rotate the gear which is behind
the regeneration knob till the time
on the unit shows your local time
and take the
c. Time of day
Advertisement
Table of Contents
