Connect The Drain Line; Mount The Main Assembly - Aquathin PEARL 30 Getting Started

11. Connect the Drain Line

Figure 11. Drain line connection (color of tubing is for
illustrative purposes)
Measure and cut a length of tubing to connect the drain
water check valve (indicated by "TO DRAIN" on the
frame assembly) to the drain water saddle valve.
IMPORTANT: Be
appropriately before cutting. If the frame of the main
assembly is not above the drain saddle valve, you will
need to loop the tubing as high as possible beneath the
sink. Be sure to allow for this loop when you measure. A
self-adhesive tubing clip has been provided to secure the
drain loop.

12. Mount the Main Assembly

With the cold water supply and drain line connected, the
main assembly can now be placed onto the screws
previously installed. Place the keyhole openings over the
screws then slide the frame horizontally onto the
mounting screws. You may wish to remove the main
assembly and adjust the screws to make the connection as
secure as possible.
16 © 2009-2016 Aquathin Corporation. All rights reserved.
sure to measure the tubing