Mount The Pump - Aquathin PEARL 30 Getting Started

(Note the arrows indicating the flow on both the pump
and the sediment pre-filter).
4. Mount the Pump (PBA)
Connect the pump to the Pump Jack on the main
assembly (see figure D7).
With the pump inlet, outlet and Pump Jack connected to
the main assembly, the pump can now be mounted with
screws in the position previously identified. (A pilot hole
using a 1⁄16" drill bit is recommended for particle board
side-walls.)
NOTE: you may rotate the face of the pressure gauge, if
needed, for easier reading.
56 © 2009-2016 Aquathin Corporation. All rights reserved.