Figure 6. Mounting the Drain Saddle Valve
follow steps 1 through 4 to mount the drain saddle valve.
NOTE: When installing the Main Assembly, mount the
frame above the position of the drain saddle whenever
possible.
(See Figure 11 on page 16).
7. Preparing to Mount the Main Assembly
When possible we
r e c o m m e n d
mounting the main
assembly on the left
sidewall
of
the
cabinet, but this is
not a requirement. .
M o u n t i n g
t h e
system as shown in
Figure 7
will save
Figure 7. Mounting Arrangement
cabinet space.
in the case of Limited Cabinet
Space
Install the screws
(Figure
thickness of the frame. (A pilot hole using a 1⁄16" drill bit
is recommended for particle board side-walls.)
13
© 2009-2016 Aquathin Corporation. All rights reserved.
8) provided allowing for the