Connect Gac Post Filter; Power-Up The Main Assembly; Connect To Ice Maker - Optional - Aquathin PEARL 30 Getting Started

15. Connect GAC Post Filter

Refer again to the PEARL
49 in Appendix C3. The GAC post-filter (CARB 6)is
typically installed just below the faucet assembly and is
easily supported by the tubing and Speedfit® fittings.
Measure and cut a length of tubing to connect the outlet
of the GAC post-filter to the faucet assembly. Placing the
post-filter near the tank will make it easy to service when
needed.
Connect one end of the tubing to the threaded stem of the
chrome faucet assembly using the ¼" compression
fittings provided. (See diagram on page 49 in Appendix
C3.)
Connect the opposite end of the tubing to the outlet of the
GAC post-filter.
Finally, measure a length of tubing to connect the storage
tank to the GAC post-filter.
Leave the handle on
the tank ball valve
closed at this point.
16. Power-up the
Main Assembly
Connect the provided
transformer to the main
assembly as shown.
17. Connect to Ice Maker – optional
Before connecting the GAC post-filter to the faucet
assembly (as described above), connect the GAC post-
18 © 2009-2016 Aquathin Corporation. All rights reserved.
installation diagram on page
Figure 14. Transformer con-
nection