Table of Contents
Advertisement
5) Solder joints with caution
Wrap a wet rag around the bypass valve to prevent inter-
nal damage by heat transfer as you proceed with solder-
ing. It is recommended that you leave at least
6" (152mm) between the bypass valve and solder joints
when soldering pipes that are connected on the bypass
valve. Failure to do this can cause interior damage to the
bypass valve.
7. Identifying Water Inlet vs. Outlet
As you stand in
front of the unit, the
inlet is on your
right, while the out-
let is on the left.
Alternatively,
you
can look for the
arrow near the by-
pass valve outlet
indicating
away
from the unit, as
shown in
figure
10.
9. Connecting
to Drain Valve
Connect the 5/8
inch
black
tube
provided
to
the
drain hose barb as
shown in
figure
11.
15
© 2007-2009 Aquathin Corporation. All rights reserved. Rev 20091029
Fig. 10. The arrows on the bypass
valve (as shown) indicate water inlet
and outlet.
Fig. 11. Connect the drain line as
shown
Advertisement
Table of Contents
