Table of Contents
Advertisement
remember that the label you design in your application must fit on the peeled label and
not bleed into the media backing.
The following specific features in the printer driver are important for GHS printing.
Paper Size is set to the exact size of your label media, including the release
liner.
Borderless Printing is set to OFF. This is the required value for GHS drum
labels on marked media. Do not change this value.
Use Marks is set to MARKS ONLY because the pre-diecut media will have
marks on the back to indicate label position. If your media does not have marks
you may not be able to use the printer in this configuration. If this is the case,
contact Neuralog Support.
Rotate 180 can be On or Off, depending on end-use applicator requirements.
Mark Adjust may be used to center the label on the page in the continuous
direction.
© 2015 NeuraLabel Printing Solutions, A Neuralog Company
Figure: Sample GHS Fanfold Media
Types of Continuous Printing
71
Advertisement
Table of Contents
