Table of Contents
Advertisement
If you are printing text with solid colors (business graphics) and you want to optimize
PC performance (the time it takes to generate the file; not the time it takes to print the
file.)
Best Quality should not be used for high resolution photo-like content because the file
size can grow significantly in those cases.
4.3.2.2.15 Mark Adjust
The Mark Adjust driver setting is found in the Advanced Options Dialog of the
NeuraLabel Printer Driver.
Mark Adjust is used to refine the placement of the label image with respect to the label
form. It is applicable when Marks Only or Mixed is selected for Use Marks. It has no
affect when Use Marks is set to No Marks as is the case with a Web Press.
NeuraLabel 300x continuous media has a mark on the back of each continuous label
page. This allows the printer to monitor the media and determine the label size. Mark
Adjust is used to adjust the label placement with respect to the mark.
Mark Adjust may have any value from -300 to 300. The default value is 10.
If you find that the printed label is not centered on the page in the continuous direction,
use Mark Adjust. The marked end of the continuous media is the top of the page.
To move the printed image down the page, decrease the value of Mark Adjust.
To move the printed image up the page, increase the value of Mark Adjust.
10 units of Mark Adjust is about 1/10 inch.
Mark Adjust may be a negative or positive value or it may be 0.
It is likely that this value will not need to be changed or that it would only need to be
changed by a small amount.
Reasons Mark Adjust would need changing:
The media does not meet the NeuraLabel 300x media specifications.
The user wants to change the position of the label on the continuous form.
Small discrepancies in the printer may require a small adjustment.
NOTE: Mark Adjust can be set by printing a single label and adjusting the value based
on the resulting label image placement.
4.3.2.2.16 Leading Edge Adjust
The Leading Edge Adjust driver setting is found in the Advanced Options Dialog of
the NeuraLabel Printer Driver.
Leading Edge Adjust is used to refine the placement of the label image with respect to
the label form on the leading edge (first page) of the media. It does not affect any other
© 2015 NeuraLabel Printing Solutions, A Neuralog Company
Label Printing Options
53
Advertisement
Table of Contents
