Power Connector Cable - HP ENVY x360 15 Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the fan, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the Power button board (see
Remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Remove the five Phillips M2.5×5.7 screws (2) that secure the display left hinge to the keyboard/top cover.
3. Swing the display left hinge (3) up and back until the power connector cable is accessible.
4. Release the power connector cable from the retention clips (4) and routing channel built into the keyboard/
top cover.
5. Remove the power connector cable (5).
Bottom cover on page
Battery on page 29).
Power button board on page
27).
42).
Component replacement procedures
Spare part number
L20106-001
45