Sd Card Board - HP ENVY x360 15 Maintenance And Service Manual

SD card board

NOTE: The SD card board spare part kit does not include the SD card board bracket or SD card board cable.
The SD card board cable is available using spare part number L20105-001.
Description
SD card board
Before removing the SD card board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the SD card board:
1. Release the ZIF connector (1) to which the SD card board cable is connected, and then disconnect the SD
card board cable from the SD card board.
2. Remove the two Phillips M2.0×3.2 screws (2) that secure the SD card board to the keyboard/top cover.
3. Remove the SD card board (3).
Reverse this procedure to install the SD card board.
Bottom cover on page
Battery on page 29).
27).
Component replacement procedures
Spare part number
L20130-001
41