Hard Drive - HP ENVY x360 15 Maintenance And Service Manual

Hard drive

Description
1-TB, 7200-rpm, 7.0-mm hard drive (does not include cable or rubber sleeve)
Before removing the hard drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the hard drive:
1. Release the zero insertion force (ZIF) connector (1) to which hard drive cable is connected, and then
disconnect the hard drive cable from the system board.
2. Release the hard drive (2) by lifting the right side of the drive until it rests at an angle.
3. Remove the hard drive (3).
4. If it is necessary to remove the hard drive cable and/or hard drive rubber sleeve:
30 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 29).
27).
Spare part number
L23942-006