Solid-State Drive - HP ENVY x360 15 Maintenance And Service Manual

Solid-state drive

Description
1-TB, 2280, PCIe3×4, NVMe solid-state drive with TLC
512-GB, M.2 2280, PCIe3×4, NVMe, SS solid-state drive with TLC
512-GB, 2280, PCIe, NVMe solid-state drive
360-GB, 2280, PCIe3×4, NVMe solid-state drive with TLC
256-GB, M.2 2280, PCIe3×4, NVMe, SS solid-state drive with TLC
256-GB, 2280, PCIe, NVMe solid-state drive
128-GB, M.2 2280-SATA3 solid-state drive with TLC
16-GB, 2280, PCIe, NVMe solid-state drive
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the solid-state drive:
1. Remove the Phillips M2.0×3.0 screw (1) that secures the solid-state drive to the system board.
2. Remove the solid-state drive (2) by pulling it away from the connector.
NOTE:
32 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page
Solid-state drives are designed with notches to prevent incorrect insertion.
27).
29).
Spare part number
L19456-001
L19455-001
L19457-001
L19454-001
L19452-001
L19453-001
L19451-001
L19457-001