Table of Contents
Advertisement
2.4.4
E-Keying
E-Keying has been defined in the AMC.0 R2.0 Specification to prevent module damage, prevent
misoperation, and verify bay connection compatibility. The FRU data contains the AMC point-to-point
connectivity record as described in Section 3.9.1 of the AMC.0 R2.0 specification.
The Set/Get AMC Port State IPMI commands defined by the AMC.0 specification are used for either granting
or rejecting the E-keys.
2.4.5
MMC Firmware Code
MMC firmware code is organized into boot code and operational code, both of which are stored in a flash
module. Upon an MMC reset, the MMC executes the boot code and performs the following:
1 Self test to verify the status of its hardware and memory.
2 Performs a checksum of the operational code.
3 Communicates with the Firmware Upgrade Manager (FWUM) in order to inform the MMC watchdog that the
actual MMC firmware is suitable for execution.
Upon successful verification of the operational code checksum, the firmware will jump to the operational
code.
2.4.6
MMC & FWUM Firmware Upgrade Procedure
It is important to use compatible, MMC, FWUM versions. Since all these software and hardware solutions are
exchanging information, they must be in synch. Please always follow Kontron documentation for all your
upgrades.
The recommended upgrade sequence must be:, FWUM, MMC,.
MMC Firmware upgrades can be done by using IPMITOOL from the AMC Carrier or remotely on the chassis. It
has been designed to be upgraded through any IPMI interface without payload impact
FWUM upgrade should not be required since its functionality is very specific. However, FWUM Firmware
upgrade is done using IPMIFWU utility. This is a Linux utility developed by Kontron that use the serial port of
any computer to exchange with the FirmWare Upgrade Manager (FWUM) in order to upgrade the FWUM or the
MMC firmware. This tool doesn't need the KCS driver to run over the Carrier AMC (it doesn't use the IPMI
interfaces) but requires a serial cable hook on the AMC module.
Type the following to perform MMC firmware upgrade
ipmifwu -p -f <FWUM_firmware_filename> -m -p /dev/ttyS0 -S<enter>
Note:
The tool is available on request. Please contact Technical Support for cable instructions.
During FWUM firmware upgrade the MMC is held in reset. A firmware upgrade might
have a payload impact.
WARNING
8
Board Features
AM450x User's Guide
Advertisement
Table of Contents
