Omron 3G8F7-CRM21 User Manual page 212

Preparing and Mounting Flat Connectors on the Cables
Note
192
3-2 Hold the cable to prevent dislocation. Close the cover to sandwich the
cable.
When it is for cable extension or for connecting a Terminating Resistor, be
sure to insert the cable tip all the way to the cable stopper in the cover. Be
sertain the cable won't come out.
4. Pressure-Welding the Connector
Use a DWT-A02 Special Tool (Pliers) to pressure-weld and connector the
cable.
4-1 Place the Connector on the pressure-welding block of the DWT-A02
Pliers.
Align the Connector side so that it faces the datum shown in the picture
below (shaded faces). Thus the center (see arrow) of the connector
cover is aligned with the center of the pressure-welding block on the
Pliers.
4-2 Squeeze the Pliers firmly until the lock on the Connector clicks into
place.
Special Tool (Pliers)
Datum to place the
Connector
Connector cover
Section E-4