Preparing Connectors For Flat Cable I - Omron 3G8F7-CRM21 User Manual

Preparing and Mounting Flat Connectors on the Cables
E-4-2

Preparing Connectors for Flat Cable I

Preparing and
Mounting the DCN4-
TR4 Flat Connector
Sockets
Names of Flat Connecter Socket components
Cover
Cable confirmation slot
1. Cutting the Cable (required only when the cable is extended or when a
Terminating Resistor is connected)
At the tip of the cable, cut the cable perpendicular to the cable length.
To prevent short-circuiting, use a sharp cutting tool such as a nipper. After
cutting, confirm that there is no remaining wire coming out.
2. Setting the Cable Stopper (required only when the cable is extended or
when a Terminating Resistor is connected)
For extending cables or connecting a Terminating Resistor, the cable can end
within the Connector. Thus place a cable stopper in advance.
Close the cover of the Flat Connector I Socket. Secure the hook. Press down
the cable stopper until it clicks into place and does not return.
Cable labels (Black,
blue/green, white, and red)
Black
Cable stopper
Section E-4
Housing
185