Omron 3G8F7-CRM21 User Manual page 207

Preparing and Mounting Flat Connectors on the Cables
Note
Precautions for Correct Use
Once it is attached, the housing cannot be removed from the cover. If you
attempt to remove it forcibly, you may damage the connector.
5. Pressure-Welding the Connector
Use a DWT-A01 Special Tool (Pliers) to pressure-weld and connect the cable.
5-1 Align the center (see arrow) of the connector cover with the center of
the pressure-welding block on the DWT-A01 Pliers.
Special Tool (Pliers)
5-2 Squeeze the Pliers firmly until the lock on Connector clicks into place.
•Do not pressure-weld the connector cover at the edge.
•Do not use the back of pressure-welding block to pressure-weld the
connector cover.
•Set the Connector in the correct orientation.
OK
NG
5-3 Confirm that it is properly pressure-welded as shown below:
Connector cover
It must be locked on both right and left.
No space here.
Section E-4
NG
187