Omron 3G8F7-CRM21 User Manual page 204

Preparing and Mounting Flat Connectors on the Cables
Precautions for Correct Use
184
5. Pressure-Welding the Connector
Use a DWT-AT01 Special Tool (Pliers) to pressure-weld and connect the
cable.
5-1 Align the center (see arrow) of the connector cover with the center of
the pressure-welding block on the DWT-A01 Pliers.
Special Tool (Pliers)
5-2 Squeeze the Pliers firmly until the lock on the connector clicks into
place.
•Do not pressure-weld the connector cover at the edge.
•Do not use the back of pressure-welding block to pressure-weld the
connector cover.
•Set the Connector in the correct orientation.
OK
NG
5-3 Confirm that it is properly pressure-welded as shown below:
Connector cover
It must be locked on both right and left.
No space here.
Section E-4
NG