At The Local Site: Initial Power-Up - Black Box ServLink ACR3500A Manual

SERVLINK™

3.2 At the Local Site: Initial Power-Up

When all of your equipment is in place, take these steps to power up the devices at
your local site (you can power up the remote PC and monitor at any time):
1. If you've installed Power Management Modules: Turn the Modules ON.
2. Turn ON the ServLINK by pressing the large button marked
ServLINK's front panel. The ServLINK will begin booting (it runs Microsoft
Windows NT).
3. Turn ON the attached monitor and any other powered attached devices and
peripherals.
4. If you're connected to a network, follow your normal operating procedures to
log into your network as usual. You should be able to start working with the
ServLINK right away: It ships with the default Windows NT user name
"Administrator" and no password, so until you change these settings, you can
simply press [Enter] to log in.
Once you've logged in, pcANYWHERE loads, followed by the ServLINK
application. Once the system has completely booted, you should see the line
"ServLINK Remote Control System - Main Menu" at the top of your screen.
(Please note that ServLINK ships with only the TCP/IP network protocol
installed and is configured with a static IP address. Consult with your network
administrator about how to configure the network to support the ServLINK.)
5. Turn ON any attached KVM switches.
6. Turn ON your CPUs.
Your system should now be ready for initial configuration.
Before having the ServLINK serviced—if you ever need to—power it
down by turning it OFF and unplugging it, or by shutting OFF power to it
through its Power Management Module. (Also power down all of the
attached computers if possible.)
30
NOTE
on the