Attaching Power Directly (No Power Management Modules) - Black Box ServLink ACR3500A Manual

CHAPTER 3: Installation
3.1.8 A P D (N P M M )
TTACHING OWER IRECTLY O OWER ANAGEMENT ODULES
If your system doesn't include Power Management Modules, take these steps to
hook it up to AC power: First make sure that the ServLINK's power switch is OFF,
then run the included power cord (shown in Figure 3-14) between the IEC 320
power connector on the ServLINK and an appropriate AC wall outlet. (This outlet
must be near the equipment and must be easily accessible so that the ServLINK
can be easily unplugged if it ever needs servicing.) Plug in the rest of the attached
devices.
Power cord
Figure 3-14. Attaching the power cord to the ServLINK.
29