Installation; At The Local Site: Making Device And Power Connections; Attaching Primary Equipment - Black Box ServLink ACR3500A Manual

The illustrations in this chapter were made from a prototype unit. The
arrangement of the connectors on the back of your unit might be
slightly different.

3.1 At the Local Site: Making Device and Power Connections

3.1.1 A P
TTACHING
To install the ServLINK™ at your local site (the site where the computers you want
to access are), first power down all of the computers and KVM switches that you
will be attaching, directly or indirectly, to your ServLINK system. Then connect
your peripherals to the ServLINK, as shown in Figure 3-1:
1. Plug the VGA monitor you wish to use with your ServLINK into the port
highlighted dark blue and labeled
2. Plug the included PS/2
lavender and labeled
ServLINK port highlighted light green and labeled
Figure 3-1. Attaching the peripherals to the ServLINK.

3. Installation

E
RIMARY QUIPMENT
® type keyboard into the ServLINK port highlighted
. Plug the included PS/2 type mouse into the
NOTE
on the back of your ServLINK unit.
CHAPTER 3: Installation
.
VGA Monitor Cable
PS/2 Mouse Cable
PS/2 Keyboard Cable
17