Attaching Power Management Modules (Power And Serial Data, Optional); A Installing The Module Controlling Power To The Servlink - Black Box ServLink ACR3500A Manual

3.1.7 A P
TTACHING
How you attach a ServLINK Power Management Module (our product code ACRPWR)
to a main ServLINK unit depends on whether the Module will be controlling
power to the ServLINK itself (see Section 3.1.7.A) or to an attached computer,
router, etc. (see Section 3.1.7.B). Important: Any non-included power cords used
with the Management Modules must be rated for 15 amps minimum. For more
complete information about these Modules, consult their own manual.

3.1.7.A Installing the Module Controlling Power to the ServLINK

Take these steps to install any Module you'll be using to control power to the
ServLINK itself:
1. If the ServLINK is powered, power it down.
2. Plug one of the RJ-45 cables included with the Management Module into the
"DATA IN" port on the Module, as shown in Figure 3-8.
Figure 3-8. Attaching an RJ-45 cable to the Power Management Module.
3. Plug the other end of this cable into the port marked "DATA" on your
ServLINK's Access Card, as shown in Figure 3-9.
Figure 3-9. Attaching the same cable to the ServLINK.
M
OWER ANAGEMENT
M (P
ODULES OWER AND
CHAPTER 3: Installation
S D , O
ERIAL ATA PTIONAL
RJ-45 control cable to
RJ-45 control cable from
Management Module
)
ServLINK
23