Safety Screen Replacement - Jøtul GF 160 DV IPI Installation And Operation Instructions Manual

7. Install replacement side glass and gasket:
• Wrap the new gasket material evenly around the
edge of the glass, peeling back the protective strip to
expose the adhesive, leaving a 1/2" overlap at the end
seam. Press the adhesive side down onto the glass
surface. Do not stretch the gasket.
• Place the panel within the frame and reinstall it in
the firebox using the four M6 nuts previously removed.
8. Adjust the Side Plate position to evenly align the rear
edge seam with the opposite side plate and retighten
the base bolt.
9. Re-attach the upper bracket strap to the firebox using
the original M6 hex bolt.
10. Replace the Exhaust Baffle and Burner assembly.
• Readjust and tighten the air shutter following the
guidelines in Section 14, Air Shutter Adjustment on
page 24.
11. Replace the front Front Glass Frame, and Top Plate.
Safety Screen Maintenance and
Replacement
Cleaning
The integrated, Invisimesh® safety screens, located
in front of the door and side glass panels, should be
periodically cleaned to remove dust, lint, and other air-
bourne debris. Over time, and with continuous exposure
to heat, these materials can contribute to variations in the
screen hue.
Open the front door and clean both sides of the screen
using a fine, soft bristle brush or vacuum attachment.
APPLY ONLY VERY GENTLE PRESSURE TO AVOID
DAMAGING THE SCREEN.
Front Safety Screen Replacement Kit 158062
Tools: #4 hex key
The front safety screen is easily accessible from the back
of the door.
Use a #4 Hex Key to remove the four button head screws
and retainer brackets as shown in fig. 16.4.
The replacement screen and frame installs as a single
unit using the original four brackets and screws.
Figure 16.4.
Remove front
screen retainer
screws and
brackets.
GF 160 DV IPI 12/17
33