Log Set - Jøtul GF 160 DV IPI Installation And Operation Instructions Manual

12. Install Burner Media
Do not install burner media until after all
other accessory installations or component
adjustments have been completed.

Log Set 158045

NOTE: LOG COMPONENTS ARE FRAGILE.
WEAR SAFETY GLOVES AND HANDLE LOGS WITH CARE.
Contents:
#1 Base Log ........................... 226264
#2 Left Log............................. 226265
#3 Right Log.......................... 226266
Ember Stones ................. 6 oz.
Inspect the log parts and report any damage to your
dealer. DO NOT INSTALL DAMAGED LOGS.
1. Base Log: Engage the holes in the underside of Base Log
#1 with the twp pins on the burner base.
2. Right Log: Rest the end of the Right Log #2 in the small
pocket on the Base Log as shown in fig. 12.2.
Rest the upper end of the log against the back corner of
the firebox as shown in fig. 12.1.
3. Left Log: Engage the hole in the charred end of the Left
Log #3 with the Base Log pin and lean it up against the
back corner of the firebox. See figs. 12.1 and 12.2.
4. If desired, spread the Ember Stones over the Burner
Base in a thin layer. DO NOT COVER GAS PORTING
HOLES ON THE SIDES OR FRONT OF THE BURNER. PLACE
STONES OVER THE REAR PORTS ONLY AND UP TO THE
REAR FLANGE OF THE BURNER.
KEEP EMBER STONES AWAY FROM THE PILOT CARRY-
OVER AREA AND BURNER PERIMETER.
The Rock Wool included the Miscellaneous Kit is
intended as an enhancement to replicate glowing
embers. Use a toothbrush or tweezers to sparingly
apply small pinches of fibers over the front of the
burner base after the log components have been
installed. DO NOT USE THE ENTIRE QUANTITY OF
ROCK WOOL.
Please be aware that, under minimum vent
configurations, sooting may occur with Propane fuel.
Should soot develop, use a soft brush to clean the log
and remove some or all of the rock wool from the burner.
3
Figure 12.1. Fully assembled log set.
3
Figure 12.2. Rest the end of the Right Log in the small pocket
on the Base Log.
GF 160 DV IPI 12/17
2
1
2
1
21