Optional Equipment; Firebox Panel Kits - Jøtul GF 160 DV IPI Installation And Operation Instructions Manual

139894 GF 160 DV IPI 12/17
11. Accessories
Skamol Panel Contents:
• Rear Panel ..................226029
• Side Panels, 2 ..............226030
Reflective Black Glass Contents:
• Rear Panel .................. 226073
• Left Side Panel ........... 226074
• Right Side Panel ........ 226075
• Cotton Gloves, 2
INSTALL FUEL OR HIGH ALTITUDE CONVERSION
KITS BEFORE INSTALLING PANEL KITS.
THE PANELS ARE FRAGILE.
SUPPORT EACH WITH BOTH HANDS.
HANDLE THE GLASS PANELS WITH THE COTTON GLOVES
PROVIDED TO MINIMIZE FINGERPRINTS. SKIN OILS ARE
DIFFICULT TO REMOVE FROM THE GLASS SURFACE.
Pilot Assembly Shield
Figure 11.1. Install Rear Panel.
20
Tools:
• Flat head screw driver
This procedure applies to both kits.
ORIENT GLASS PANELS WITH THE
SMOOTH SIDE FACING OUT.
1. Set the Rear Panel, bottom first, behind the pilot
assembly shield and resting on the rear shelf. When
installed, the two side panels will hold the rear in place.
2. The side panels rest on the shelves at each side of the
burner. Each panel is secured by a single Retainer Tab
located within the upper corner of the firebox ceiling.
Set a panel in place against the firebox wall and use a
flat head screwdriver to pry the retainer tab down just
enough to hold the panel snug in place.
3. Repeat with the other side panel.
Figure 11.2. Install Side panels.
Retainer Tab