Remote Control; Remote Control Functions - Jøtul GF 160 DV IPI Installation And Operation Instructions Manual

139894 GF 160 DV IPI 12/17

Remote Control Functions

Pilot Mode
Set the Mode switch to ON to light the pilot. The
burner will ignite and remain on until manually
switched OFF.
Burner Control
Set the stove burner switch to REMOTE for Proflame 2

remote control.

OFF - Turns off both remote and manual burner
functionality. Switch to OFF when the stove will not be
used for an extended period of time.
Remote Transmitter
The Transmitter features a simple button layout and
informative display screen. See fig. 15.2.
LCD DISPLAY - graphically indicates temperature
settings and status of the Thermostat, Burner, and
Accent Lamp.
ON / OFF Key - controls Burner and Lamp functions.
THERMOSTAT Key - Used to set either Manual or
Thermostatic Control and index through thermostatic
functions.
UP / DOWN Arrow Key - Selects thermostat
temperature range and flame height.
MODE Key - used to select the component to be
controlled: CPI/IPI, Burner, and Accent Lamp.
The supplied Wall Mount Bracket can be used for
convenient hand-held transmitter storage.
Transmission
Thermostat
ON / OFF / SMART
Set Point
Temperature Level State
Burner
Modulation
Fan - not available
Fan Modulation
Figure 15.2. Remote transmitter display data.
28
°F
°C
OFF
ON
SMART
MAX MAX
Lamp Modulation
Initializing the System
1. Press the Controls Access Door to release its magnetic
catch and swing the panel down.
Switch the Mode to REMOTE. See fig. 15.1.
2. Install three AAA batteries into the Transmitter
handset.
3. Press the PRG button on the Left front corner of the
switch plate. The board will "beep" three times and a
yellow LED will indicate a 10-second synchronization
time limit.
4. Within 10-seconds, press the Tramsmitter ON button.
The IFC will "beep" three or four times to indicate that
it has acknowledged the transmitter command and
sets to the particular code of that Transmitter.
5. After initialization, place the Mode switch in the
REMOTE position. The hand-held transmitter can then
be used to control the burner.
To return to full Manual functionality:
• Switch the Mode to REMOTE.
• Press the red button on the until it "beeps" three
times. Within 10 seconds, press the button again until
acknowledgement is signalled.
Remote
transmitter
function keys.
Child Safety Lock-out
Low Battery Alarm
Room
Temperature
CPI Mode
AUX
(Not Applicable)
Split Valve
Blue LCD Screen
ON/OFF Key
THERMOSTAT Key
UP/DOWN Key
MODE Key