Remote Control - Jøtul GF 373 BF Installation And Operation Instructions Manual

7. Remote Control

Operation
Before using the remote handset...
Familiarize yourself with all the handset functions and
complete the Remote Control Setup procedure described in
this section.
Handset Functions
Insert two, AA batteries into the rear compartment or the
handset. The handset has been paired with the stove at the
factory.
1. Place the TESC valve Master power switch in the ON
position. Fig. 16, #1.
NOTE: For safety reasons, any button must be pressed
and released for the command to be recognized. Do
not press and hold the button down, unless otherwise
instructed.
2. Grasp your hand around the back of the handset to
unlock its functions. An audible signal and green unlock
light will indicate that the handset is unlocked and
ready to accept commands. The handset will remain
unlocked and available to accept commands as long as
you continue to hold it.
Display Read-outs -
Fig. 18.
1. Mode Status: MAN (Manual)
Zzz (Sleep), Thermostat or Timed
2. Time: (12 hour or 24 hour display)
3. Day of Week
4. WIFI: (Valve and Handset are within command range)
5. Burner Status: (OFF / ON)
6. Room Temperature: (°C / °F)
7. Battery Condition: (RC = Handset, FC = Fire Control)
8. Handset Unlocked - Green when illuminated
9. Light Sensor (for Display backlight)
10. Handset Settings: (Press to change settings)
11. Mode Settings: (Press to change modes)
12. Increase Flame
13. Decrease Flame
14. Power - Press to turn burner ON and OFF.
1
3
5
7
9
11
13
Fig. 18.
Operation
To Turn Burner ON: Grasp handset around the back and
sides to unlock it, (Signal and green light). Using the
other hand, touch and hold a finger on the power
button for about 3 seconds. (An audible signal and
green light will flash.) Immediately release the power
button when "PILOT" is displayed. A second green flash
and a longer beep will signal to release the power
button. The pilot should ignite within a few seconds
followed by the burner.
NOTE: If the power button is held for more than a few
seconds after the second flash/beep, the command is
ignored for safety reasons. Similarly, if it is released too
soon before the word PILOT appears, the command is
also ignored. The system control is designed to ensure
that unintended ignition cannot occur.
To Turn Burner OFF – Grasp handset to unlock it, then
press and release power button once.
139807_R4 GF 373 BF CE 7/17
2
4
6
8
10
12
14
17