Adjusting The Rear Wheel Toe-In; Cooling System Maintenance; Cooling System Safety; Removing Debris From The Cooling System - Toro Reelmaster 5510-D Operator's Manual

Adjusting the Rear Wheel
Toe-in
Service Interval: Every 800 hours—Check the rear
wheel toe-in.
1. Rotate the steering wheel to position the rear
wheels straight ahead.
2. Loosen the jam nut on each end of the tie rod
(Figure 93).
Note:
The end of the tie rod with the external
groove is a left-hand thread.
Figure 93
1. Jam nut
2. Tie rod
3. Using the wrench slot, rotate the tie rod
4. Measure the distance at the front and rear of the
rear wheels at axle height.
Note:
The distance at the front of the rear
wheels should be less than 6 mm (1/4 inch) of
the distance measured at the rear of the wheels.
5. Repeat this procedure as required.
g004136
3. Wrench slot
Cooling System
Maintenance

Cooling System Safety

•
Swallowing engine coolant can cause injury
or death; keep out of reach from children and
pets.
•
Discharge of hot, pressurized coolant or touching
a hot radiator and surrounding parts can cause
severe burns.
– Always allow the engine to cool at least 15
minutes before removing the radiator cap.
– Use a rag when opening the radiator cap, and
open the cap slowly to allow steam to escape.
Removing Debris from the
Cooling System
Service Interval: Before each use or daily (More
frequently in dirty operating
conditions).
Every 100 hours—Inspect the cooling-system
hoses.
Every 2 years—Flush and replace the
cooling-system fluid.
1. Shut off the engine and remove the key from the
ignition switch.
2. Thoroughly clean all debris out of the engine
area.
3. Unlatch the clamp and pivot open the rear
screen (Figure
59
94).