Adjusting The Rear Wheel Toe-In - Toro Reelmaster 5010-H Operator's Manual
Traction unit
Hide thumbs
Also See for Reelmaster 5010-H:
- Diagnostic manual (476 pages) ,
- Service manual (335 pages) ,
- Operator's manual (84 pages)
Table of Contents
Advertisement
Checking the Rear-Wheel Alignment (continued)
Front of the traction unit
6 mm (1/4 inch) or less than the rear of the tire
4. If the measurement is greater than 6 mm (1/4 inch), adjust the rear wheel toe-in.
Adjusting the Rear Wheel Toe-in
1. Loosen the jam nut
rod
Note:
groove is a left-hand thread.
2. Use the wrench flat
3. At axle height, measure the center-to-center
distance at the front and rear of the steering
tires.
Note:
correct if the difference between the front
wheel measurement and the rear wheel
measurement is 6 mm (1/4 inch) or less.
4. Repeat steps
5. Tighten the jam nuts.
3464-478A
on each end of the tie
.
The end of the tie rod with the external
to rotate the tie rod.
The rear wheel toe-in adjustment is
1
and
2
as required.
G416236
Center-to-center distance
G416237
Page 6–32
Maintenance: Drive System Maintenance
Advertisement
Table of Contents
