Installing The Cutting Units - Toro Reelmaster 5510-D Operator's Manual

3

Installing the Cutting Units

Parts needed for this procedure:
1 Right, front hose guide
1 Left, front hose guide
Procedure
1. Remove the reel motors from the shipping
brackets.
Note:
Discard the shipping brackets.
2. Remove the cutting units from the cartons.
3. Assemble and adjust the cutting units as
described in the Operator's Manual for the
cutting units.
4. Make sure that the counter weight
installed to the proper end of each cutting unit
as described in the Operator's Manual for the
cutting units.
1. Counter weight
5. Mount the turf-compensation spring to the same
side of the cutting unit as the reel-drive motor.
Reposition the turf-compensation spring as
follows:
Note:
All cutting units are shipped with the
turf-compensation spring mounted to the right
side of the cutting unit.
(Figure
Figure 3
A. Remove the 2 carriage bolts and nuts
securing the rod bracket to the cutting-unit
tabs
1. Turf-compensation spring
2. Rod bracket
B. Remove the flange nut securing the
spring-tube bolt to the carrier-frame tab
(Figure
C. Mount the spring-tube bolt to the opposite
tab on the carrier frame and secure with the
flange nut.
Note:
3) is
side of the tab as shown in
1. Opposite carrier-frame tab
D. Mount the rod bracket to the cutting-unit
tabs with the carriage bolts and nuts
5).
Important:
and cutting unit 5 (right front), use the
rod-bracket-mounting nuts to install
the hose guides to the front of the
cutting-unit tabs
g003320
The hose guides should lean toward the
center cutting unit
8).
Note:
cutting units, make sure that the hairpin
cotter is installed in the spring-rod hole next
to the rod bracket. When not installing or
removing the cutting units, the hairpin cotter
must be installed in the hole in the end of
the rod.
11
(Figure 4).
Figure 4
3. Spring tube
4). Remove the assembly.
Position the bolt head to the outer
Figure 5
2. Rod bracket
On cutting unit 4 (left front)
(Figure 6
(Figure 7
When installing or removing the
g003949
Figure 5.
g003967
(Figure
and Figure 7).
and Figure