After Operation Safety; Hauling The Machine; Hydraulic-Valve Solenoid Functions; Operating Tips - Toro Reelmaster 5510-D Operator's Manual

After Operation Safety

•
Clean grass and debris from the cutting units,
mufflers, and engine compartment to help prevent
fires. Clean up oil or fuel spills.
•
If the cutting units are in the transport position, use
the positive mechanical lock (if available) before
you leave the machine unattended.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Shut off the fuel before storing or transporting the
machine.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
•
Keep all parts of the machine in good working
condition and all hardware tightened, especially
blade-attachment hardware.
•
Replace all worn or damaged decals.

Hauling the Machine

•
Use full-width ramps for loading the machine onto
a trailer or truck.
•
Tie the machine down securely.
Hydraulic-Valve Solenoid
Functions
Use the list below to identify and describe the different
functions of the solenoids in the hydraulic manifold.
Each solenoid must be energized to allow the function
to occur.
Solenoid
Front reel circuit
SP2
SP1 Rear reel circuit
SVRV Lift/lower cutting units
SV1 Lift/lower front cutting units
SV3 Lift/lower rear cutting units
SV2 Raise any cutting units
Function

Operating Tips

Becoming Familiarized with the
Machine
Before mowing grass, practice operating the machine
in an open area. Start and shut off the engine.
Operate in forward and reverse. Lower and raise the
cutting units and engage and disengage the reels.
When you feel familiar with the machine, practice
operating up and down slopes at different speeds.
Understanding the Warning
System
If a warning light comes on during operation, stop the
machine immediately and correct the problem before
continuing operation. Serious damage could occur if
you operate the machine with a malfunction.
Mowing
Start the engine and move the engine-speed switch
to the F position. Move the Enable/Disable switch
AST
to the E position and use the Lower Mow/Raise
NABLE
lever to control the cutting units (the front cutting units
are timed to lower before the rear cutting units). To
move forward and cut grass, press the traction pedal
forward.
Transporting the Machine
Move the Enable/Disable switch to the D
position and raise the cutting units to the T
position. Move the Mow/Transport lever to the
T position. Be careful when driving between
RANSPORT
objects so you do not accidentally damage the
machine or cutting units. Use extra care when
operating the machine on slopes. Drive slowly and
avoid sharp turns on slopes to prevent rollovers.
Lower the cutting units when going downhill for
steering control.
46
ISABLE
RANSPORT