Adjusting The Rear Wheel Toe-In; Figure 139 - Toro 03956 Operator's Manual

Note:
The rear wheel toe-in adjustment is
correct if the difference between the front wheel
measurement and the rear wheel measurement
is 6 mm (1/4 inch) or less.

Figure 139

1. Front of the traction unit
2. 6 mm (1/4 inch) or less
than the rear of the tire
4. If the measurement is greater than 6 mm (1/4
inch), adjust the rear wheel toe-in; refer to
Adjusting the Rear Wheel Toe-in (page
Adjusting the Rear Wheel
Toe-in
1. Loosen the jam nut on each end of the tie rod
(Figure 140).
Note:
The end of the tie rod with the external
groove is a left-hand thread.
Figure 140
1. Jam nut
2. Tie rod
2. Using the wrench flat to rotate the tie rod.
(Figure 139).
g009169
3. Center-to-center distance
76).
g004136
3. Wrench flat
3. At axle height, measure the center-to-center
distance at the front and rear of the steering
tires.
Note:
The rear wheel toe-in adjustment is
correct if the difference between the front wheel
measurement and the rear wheel measurement
is 6 mm (1/4 inch) or less.
4. Repeat steps
5. Tighten the jam nuts.
76
2 and 3 as required.