Checking The Engine-Oil Level - Toro Reelmaster 5510-D Operator's Manual

Biodiesel
This machine can also use a biodiesel blended fuel of
up to B20 (20% biodiesel, 80% petroleum diesel).
Sulfur content: Ultra-low sulfur (<15 ppm)
Biodiesel fuel specification: ASTM D6751 or
EN14214
Blended fuel specification: ASTM D975, EN590,
or JIS K2204
Important:
The petroleum diesel portion must
be ultra-low sulfur.
Observe the following precautions:
•
Biodiesel blends may damage painted surfaces.
•
Use B5 (biodiesel content of 5%) or lesser blends
in cold weather.
•
Monitor seals, hoses, gaskets in contact with fuel
as they may be degraded over time.
•
Fuel filter plugging may be expected for a time
after converting to biodiesel blends.
•
Contact your authorized Toro distributor if you wish
for more information on biodiesel.
Adding Fuel
1. Park the machine on a level surface, lower the
cutting units, shut off the engine, and remove
the key.
2. Using a clean rag, clean area around fuel-tank
cap.
3. Remove the cap from the fuel tank
Figure 27
1. Fuel-tank cap
4. Fill the tank until the level is 6 to 13 mm (1/4 to
1/2 inch) below the bottom of the filler neck.
5. Install the fuel-tank cap tightly after filling the
tank.
Note:
If possible, fill the fuel tank after each use.
This minimizes possible buildup of condensation
inside the fuel tank.
Checking the Engine-Oil
Level
Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer to
Checking the Engine-Oil Level (page
(Figure 27).
g021210
25
53).