Maintenance; Recommended Maintenance Schedule(S) - Toro Reelmaster 5510-D Operator's Manual

Maintenance

Note:
Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first hour
After the first 10 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 250 hours
Every 400 hours
Every 800 hours
Every 6,000 hours
Every 2 years
Maintenance Procedure
• Torque the wheel lug nuts to 94 to 122 N∙m (70 to 90 ft-lb).
• Torque the wheel lug nuts to 94 to 122 N∙m (70 to 90 ft-lb).
• Check the alternator-belt tension.
• Check the cooling system.
• Check the hydraulic-fluid level.
• Check the reel-to-bedknife contact.
• Check the operation of the interlock switches.
• Check the engine-oil level.
• Drain water or other contaminants from water separator.
• Remove debris from the screen and radiator/oil cooler. (More frequently in dirty
operating conditions).
• Check the hydraulic lines and hoses.
• Grease the bearings and bushings (and immediately after every washing).
• Clean the battery and check the condition of it (or weekly, whichever comes first).
• Check the battery-cable connections.
• Inspect the cooling-system hoses.
• Check the alternator-belt tension.
• Torque the wheel lug nuts to 94 to 122 N∙m (70 to 90 ft-lb).
• Change the engine oil and filter.
• Service the air cleaner. Service the air cleaner earlier if the service indicator shows
red. Service it more frequently in extremely dirty or dusty conditions.
• Replace the fuel-filter canister.
• Replace the engine fuel filter.
• Check the fuel lines and connections for deterioration, damage, or loose
connections. (Or yearly, whichever comes first).
• Check the rear wheel toe-in.
• Change the hydraulic fluid.
• Change the hydraulic filters. (Or more often if the service-interval indicator is in
the red zone).
• Pack the rear wheel bearings.
• Disassemble, clean, and assemble the soot filter of the DPF or clean the soot filter
if engine faults 3251
SPN
InfoCenter.
• Flush and replace the cooling-system fluid.
• Drain and flush the hydraulic tank.
• Replace all moving hoses.
0, 3720 0, or
FMI SPN FMI
47
3720 16 display in the
SPN FMI