Rs-232C / Rs-422 Selection - FOR-A MFR-1616 Operation Manuals

2-1-4. RS-232C / RS-422 Selection

Be sure to consult your FOR-A reseller when you wish to change the RS-232C setting
to RS-422.
Do not access internal cards with the unit power ON. Always power OFF all connected
units / disconnect power cords prior to accessing the interior.
Adjustment and maintenance procedures that require accessing the unit interior
should only be performed by qualified technical personnel familiar with the equipment.
 MFR-1616
(1) Remove the 6 screws as shown below from both sides of the unit, slide the top panel
toward the back of the unit, and detach the panel from the unit.
(2) Change DIP switch settings with tweezers through the opening on the right side.
IMPORTANT
CAUTION
Use tweezers to change DIP switch
settings from the opening on the right
side.
Rear side
背面側
16